Owners manual

3/14/2016
INS5250
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
6
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Exhaust System Installation
Cat Back Exhaust System
Dual Rear Exit w/ 4.5” Pro-Series Tips
2012-16 Jeep Grand Cherokee SRT-8
PN 14466 and 14466BLK
Installation of CORSA Exhaust System:
NOTE: Apply the anti-seize lubricant (supplied) to the threads ONLY of all the clamps and flange bolts. Failure to
follow this procedure can cause nuts to seize on clamps and potentially destroy threads. After applying anti-seize
lubricant, be sure to thoroughly clean your hands, as lubricant will tarnish stainless steel. All clamps should be
tightened using a properly calibrated Torque Wrench. Using an air impact gun will
damage the clamp and reduce its ability to effectively seal the joint. It may also
cause the joint to separate, thereby causing damage to your exhaust system and
to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the
notch in the pipe. (See Fig. CLAMP)
1. Remove all exhaust system components from the shipping boxes, including clamps and hardware.
2. Locate the hanger assemblies provided in the hardware kit, the four bolts removed during step #3 of the
removal process and the two rubber grommets retained during step #8 of the removal process. (Fig. L) Using a
ratchet and 13mm deep socket, install the driver side hanger assembly with two of the bolts. (Fig. M) Slide one
of the rubber grommets onto the hanger. (Fig. N and P) Repeat process to install hanger assembly on passenger
side.
NOTE: The use of a soap and water solution may make it easier to install hangers.
3. Locate the driver side tunnel muffler, the two M10-1.5X60mm bolts and two spacers from the hardware kit, and
the two springs retained in step #2 of the removal process. (Fig. Q) Insert the bolts through the spacers. (Fig. R)
Insert the tunnel muffler hanger into the rubber grommet. (Fig. S) Insert the bolt with spacer from the rear
through the tunnel muffler flange first, then the stock flange. (Fig. T) Start threading the spring nut assemblies
onto the bolts by hand. (Fig. U) Using a ratchet with 15mm shallow socket and 13mm wrench, tighten the
bolts. (Fig. V)
NOTE: Tighten both bolts evenly, ensuring that the spacers go through both flanges and are seated against the
bolt heads. Ensure the bolt head is against the rear face of the muffler flange.
NOTE: The use of a soap and water solution may make it easier to install hangers.
INSTALLATION INSTRUCTIONS CONTINUED ON NEXT PAGE