Owners manual

3/14/2016
INS5250
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
12
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Exhaust System Installation
Cat Back Exhaust System
Dual Rear Exit w/ 4.5” Pro-Series Tips
2012-16 Jeep Grand Cherokee SRT-8
PN 14466 and 14466BLK
Back Pressure Sensor Restrictor Pill Installation
1. Locate the exhaust back pressure sensor line on the passenger side of the exhaust system. It is on the stock
piping upstream of the tunnel muffler.(Fig. KK)
2. Using pliers, release the clamp from the tubing and carefully pull the tubing off of the sensor’s barb.(Fig. LL
and MM) Leave the clamp on the stock tubing.
3. Insert the white barb fitting into the stock tubing. Using the pliers again, slide the clamp onto the joint to secure
the stock tubing onto the barb.(Fig. NN)
4. Slide the new tubing over the back pressure sensor’s barb. The fit will be tighter than the stock tubing so no
clamp should be needed.
Fig. KK Fig. LL
Fig. MM Fig. NN