Owners manual

06/02/17
INS5351
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: (440) 891.0999 · F: (440) 891-1868
3
E - M a i l : s a l e s @ C O R S A p e r f o r m a n c e . c o m · w w w . C O R S A p e r f o r m a n c e . c o m
Cat-Back Exhaust System
Dual Rear Exit w/ 5.0” Straight Cut Tips
2017+ Ford F150 Raptor 3.5L EcoBoost
PN 14397, 14397GNM, & 14397BPC
Factory Exhaust System Removal:
1. Using a 15mm deep socket and 3/8” drive ratchet, loosen the two clamps on the axle pipes located just over the
rear axle downstream of the rear muffler. (Fig. A) Using a screw driver pry open the spring clip holding the
locating pin on the driver and passenger side tailpipes. (Fig. B)
2. Using a 10mm socket, 3/8” drive ratchet, and a long extension, loosen and remove the driver and passenger side
axle pipe hanger assemblies. (Fig. C)
3. Using a 10mm socket and 3/8” drive ratchet loosen and remove the two nuts and studs holding the tailpipe
hanger assembly located to the inside of the driver and passenger side exhaust tips. (Fig. D) The tailpipes will
no longer be supported. Slightly lower the passenger side tailpipe assembly and remove rearwards. Next, slide
the driver side tailpipe assembly rearwards to free it from the connection point and maneuver the tailpipe from
over the axle and around the spare tire. (Fig. E)
4. Loosen the clamp and sleeve clamp connection located after the stock resonator using a 15mm deep socket and
ratchet. The stock clamp is welded to the resonator assembly and cannot be removed or rotated. (Fig. F)
5. Using a 10mm socket and 3/8” drive ratchet loosen and remove the two bolts holding the front muffler hanger.
(Fig. G) Next, loosen and remove the bolt holding up the rear muffler hanger assembly. (Fig. H) The rear
muffler will no longer be supported; remove by sliding it rearwards to free the muffler inlet pipes from the
connection point. (Fig. I)
6. Remove the stock sleeve clamp from the muffler inlet pipe by prying open the spring clip with a flat head screw
driver and sliding the clamp off the pipe. (Fig. J) Place the stock sleeve clamp in a safe location as it will be
reused during the installation of your new CORSA Performance Exhaust System.
7. Removal all of the hanger grommet assemblies from their corresponding hangers and store them in a safe
location as they will be reused during the installation of your CORSA Performance Exhaust System. (Fig. K)
NOTE: The use of a soap and water solution may aid in the removal of hanger grommets.
REMOVAL PICTURES ON NEXT PAGE