Owners manual

02/10/2014
INS5193
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
9
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Cat Back Exhaust System Installation
2011-14 Ford F-150 Raptor 6.2L
Single Side Exit w/ Twin 4.0” Pro-Series Tips
PN 14387, 14387BLK, 14760, 14760BLK
7. Secure the muffler in place with the supplied clamp as shown, using a 15mm socket and ratchet, making
sure to only tighten the clamp nuts just enough to hold the muffler onto the intermediate pipe. Note the
position and orientation of the clamp. (See above clamp notes & See Fig. F)
NOTE: The unbolted tailpipe hanger assemblies from the removal process should now be installed onto the
corresponding hangers on the tailpipe by pushing the rubber grommets onto the hangers. Once again, a soapy
water solution will aid in this installation process. (See Fig. G & H)
8. Locate the rear tailpipe assembly, along with the 10mm hardware to secure the hanger mounts, and the
last of the supplied clamps. Slide the expanded end of the tailpipe onto the outlet of the rear muffler. (See
Fig. I) Align the hanger mounts with the mounting holes in the chassis, and secure with a 10mm socket
and ratchet, and a long extension. Note the proper orientation of the muffler hanger mounts as shown.
Torque the 10mm bolts to factory specs. (See Fig. J,K, & L)
9. Rotate the rear tailpipe assembly until the rearmost section of the pipe is horizontal, and then secure it with
the supplied clamp as shown, using a 15mm socket and ratchet, making sure to only tighten the clamp nuts
just enough to hold the tailpipe onto the muffler. (See Fig. M)
10. Locate the tip assembly. Slide a clamp over the expanded end of the tip, and onto the end of the tailpipe.
Snugly tighten the clamp as shown using a 15mm socket and ratchet, making sure to only tighten the
clamp enough to hold the tip in place on the tailpipe. (See Fig. N)
11. Visually inspect the exhaust system position, tip alignment, clamp orientation and position, and exhaust
pipe clearance. Make any necessary adjustments at the slip joints.
12. Fully tighten the 13mm bolts on the center pipe flange. Torque to the factory specs. Next, tighten the clamp
on the factory center pipe to 45 ft-lbs.
13. Start at the front of the vehicle, and tighten the nuts on the two supplied clamps on each side of the muffler.
Torque the nuts on the clamps to 45 ft-lbs. Finally, tighten the clamp that is built into the tip to 45 ft-lbs.
14. It is STRONGLY SUGGESTED that all clamps be checked and re-tightened (if necessary) to the
recommended torque after initial road testing of the vehicle, as thermal cycling has occurred on the system.
Please wait until system has fully cooled to conduct this process.
NOTE: During cold weather start-ups, you may experience an exhaust sound that is deeper and louder in tone than
usual.
This is temporary and will diminish to normal levels once your engine has reached its normal operating temperature.
NOTE: Immediately following the installation of your exhaust system, you may experience a trace of smoke after initial
start-up. DO NOT be alarmed. The smoke is caused by the burning of a small amount of forming oil residue used in the
manufacturing process.
INSTALLATION PICTURES ON NEXT PAGE