Owners manual

02/10/2014
INS5193
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
6
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Cat Back Exhaust System Installation
2011-14 Ford F-150 Raptor 6.2L
Single Side Exit w/ Twin 4.0” Pro-Series Tips
PN 14387, 14387BLK, 14760, 14760BLK
Removal of Stock System
1. Remove both bolts that secure the flange connection on the factory center pipe using a 13mm socket and
ratchet. (See Fig. A)
2. Unbolt the muffler hanger mount from the chassis using a 10mm socket and ratchet. (See Fig. B)
3. Unbolt the front tailpipe hanger mount from the chassis using a long extension, and a 10mm socket and
ratchet. (See Fig. C)
4. Unbolt the rear tailpipe hanger mount from the chassis using a long extension, and a 10mm socket and
ratchet. (See Fig. D & E) Carefully remove the entire stock exhaust system from the vehicle by moving it
forward and down past the rear axle. (See Fig. F) The stock exhaust is removed as one piece and is fully
intact.
5. With the stock exhaust on the ground, loosen the clamp on the factory center pipe using a 15mm socket
and ratchet. (See Fig G) Rotate the center pipe until the retaining boss on the stock exhaust is aligned with
the slot and then remove the center pipe from the rest of the factory system. (See Fig. H & I)
6. Remove the factory muffler and tailpipe hangers from the rubber isolators on the hanger mounts using a
grommet puller or a similar device. (See Fig. J,K, & L) Note the position and orientation of each hanger
mount. Set aside the muffler and tailpipe hanger mounts and the retaining bolts to be reused during the
installation process.
NOTE: The use of a soapy water solution may aid in the removal and later installation of the hangers in the
rubber isolators.
7. Removal is now complete. Installation of your CORSA Performance exhaust system can now begin.
REMOVAL PICTURES ON NEXT PAGE
REMOVAL PICTURES ON NEXT PAGE