Owners manual

INS5357
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
5
02/8/2018
[e-mail] l www.corsaperformance.com
2011-14 FORD MUSTANG GT 5.0L V8
2.75” X-Pipe
Part #: 14370
INSTALLATION INSTRUCTIONS
CORSA EXHAUST
5. Adding a 2.75” clamp to the inlet side of each
CORSA Inlet Elbow Pipe.
6. Add a 70mm spherical clamp to the front of each
CORSA Spherical Adapter. Insert the Spherical
Adapter into the CORSA Elbow Pipe Inlet. Snug
the spherical connection first, using a 13mm
socket or wrench, followed by the Inlet Elbow
connection, using a 15mm socket or wrench.
7. Adjust the system accordingly, including the
rotation and overlap at each slip fit connection
and at the sleeve clamps.
8. Check clearance between the system
components and the chassis.
9. Adjust the factory axle pipes so that the exhaust
tips are centered in the tip cutouts in the factory
rear valence.
10. Torque all 70mm spherical clamps to 21 Ft-lbs.
and all 2.75” clamps to 45 FT-lbs using a torque
wrench.
NOTE: During cold weather start-ups, you may experience an exhaust sound that is deeper and louder in
tone than usual. This is temporary and will diminish to normal levels once your engine has reached its
normal operating temperature.
NOTE: Immediately following the installation of your exhaust system, you may experience a trace of smoke
after initial start-up. DO NOT be alarmed. The smoke is caused by the burning of a small amount of forming
oil residue used in the manufacturing process.
NOTE: It is strongly suggested that all clamps be checked and tightened after road testing the vehicle once
the system has cooled.