Owners manual

INS5357
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
4
02/8/2018
[e-mail] l www.corsaperformance.com
2011-14 FORD MUSTANG GT 5.0L V8
2.75” X-Pipe
Part #: 14370
WARNING! DO NOT SKIP THIS STEP!
Apply the anti-seize lubricant (supplied) to the threads
ONLY of all the clamps and flange bolts. Failure to follow
this procedure can cause nuts to seize on clamps and
potentially destroy threads.
After applying anti-seize lubricant, be sure to thoroughly
clean your hands, as lubricant will tarnish stainless steel.
All clamps should be tightened using a properly calibrated
Torque Wrench. Using an air impact gun will damage the
clamp and reduce its ability to effectively seal the joint. It
may also cause the joint to separate, thereby causing
damage to your exhaust system and to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the notch in the pipe.
INSTALLATION INSTRUCTIONS
CORSA EXHAUST
1. Remove all exhaust system components from
the shipping boxes, including clamps and
hardware.
2. You may need another person to help support
the X-Pipe and keep it from drooping, so the
exhaust does not damage the tip cutouts in the
factory rear valance.
3. Install the outlet of the CORSA X-Pipe assembly
into the factory sleeve clamps at the inlet of the
axle pipes. Using a 15MM socket or wrench to
snug the 2 bolts on the sleeve clamp. Repeat for
opposite side
4. Add a 2.75” clamp to each of the CORSA X-Pipe
inlets. Insert the CORSA Inlet Elbow Pipes into
the X-Pipe inlets. Snug connection using a
15mm socket or wrench.
Continued on Next Page . . .