Owners manual

02/17/2017
INS5343
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
7
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Exhaust System Installation
Cat Back Exhaust System
2016 Shelby GT350
PN 14348
13. Adjust the system accordingly, including the adapter overlap on the stock sleeve clamps, the axle pipe
depth and rotation, and the rear muffler depth and rotation. Loosen both the x-pipe to axle pipe
connection clamp and the axle pipe to rear muffler connection clamp. Adjust and hold the axle pipe
and rear muffler in position while tightening the clamps. Check the position of all hangers to make
sure they are properly seated within their corresponding grommets. Check clearances between the
system components and chassis. At this time, tighten all clamps to 45ft-lbs using the torque wrench
and 15mm socket.
14. Locate the rear diffuser and stock hardware removed during step #1 of the stock removal
instructions. Position the rear diffuser and reinstall all the push pins. Next, using a 13mm
socket and 3/8” drive ratchet, install and tighten the two bolts at the axle pipe hanger
grommets and the two bolts near the rear bumper connection. (Fig. T) This concludes the
installation of your Corsa Performance exhaust system. (Fig. U)
NOTE: During cold weather start-ups, you may experience an exhaust sound that is deeper and
louder in tone than usual. This is temporary and will diminish to normal levels once your engine
has reached its normal operating temperature.
NOTE: Immediately following the installation of your exhaust system, you may experience a trace
of smoke after initial start-up. DO NOT be alarmed. The smoke is caused by the burning of a small
amount of forming oil residue used in the manufacturing process.
INSTALLATION PICTURES ON NEXT PAGE