Owners manual

02/17/2017
INS5343
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
5
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Exhaust System Installation
Cat Back Exhaust System
2016 Shelby GT350
PN 14348
Installation of CORSA Exhaust System:
NOTE: Apply the anti-seize lubricant (supplied) to the threads ONLY of all the clamps and flange bolts. Failure to
follow this procedure can cause nuts to seize on clamps and potentially destroy threads. After applying anti-seize
lubricant, be sure to thoroughly clean your hands, as lubricant will tarnish stainless steel. All clamps should be
tightened using a properly calibrated Torque Wrench. Using an air impact gun will
damage the clamp and reduce its ability to effectively seal the joint. It may also
cause the joint to separate, thereby causing damage to your exhaust system and
to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the
notch in the pipe. (See Fig. CLAMP)
1. Remove all exhaust system components from the shipping boxes, including clamps and hardware.
2. Locate the valve actuator relocation brackets along with the valve actuators and hardware
removed during step #7 of the stock exhaust removal instructions. (Fig. G.) Install the
actuator onto the bracket and tighten down using an 8mm socket and 1/4” drive ratchet
reusing the original hardware. The spring on the actuator should wrap around the larger
center pin on the bracket. (Fig. H)
3. Starting on the driver side, using a 13mm socket and 3/8” drive ratchet remove the top bolt
securing the rear most hanger bracket located just above the tip bezels. Next, mount the
relocation bracket to the hanger grommet assembly using the top hole. (Fig. I) Confirm the
clearances between the valve actuator bracket and the vehicle chassis and tighten down the
bolt. Connect the harness to the valve actuator and slide the red clip on the harness plug to
secure the connection.
NOTE: The stock valve actuators must be attached to the valve relocation bracket and the
harness must be plugged into the actuator in order to maintain driving mode functionality.
4. Repeat step #3 for the passenger side. The valve bracket assembly will be rotated and flip
180° relative to the driver side orientation. In this orientation, use the top hole on the
bracket assembly when mounting to the vehicle chassis.
INSTALLATION INSTRUCTIONS CONTINUED ON NEXT PAGE