Owners manual

02/17/2015
INS5299
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: [phone] · F: [phone]
5
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Exhaust System Installation
Cat Back Exhaust System
Dual Rear Exit w/ 4.5” Pro-Series Tips
2015 Ford Mustang GT 5.0L V8
PN 14328(BLK), 14332(BLK), 14335(BLK), 14337(BLK)
Installation of CORSA Exhaust System:
NOTE: Apply the anti-seize lubricant (supplied) to the threads ONLY of all the clamps and flange bolts. Failure to
follow this procedure can cause nuts to seize on clamps and potentially destroy threads. After applying anti-seize
lubricant, be sure to thoroughly clean your hands, as lubricant will tarnish stainless steel. All clamps should be
tightened using a properly calibrated Torque Wrench. Using an air impact gun will
damage the clamp and reduce its ability to effectively seal the joint. It may also
cause the joint to separate, thereby causing damage to your exhaust system and
to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the
notch in the pipe. (See Fig. CLAMP)
1. Remove all exhaust system components from the shipping boxes, including clamps and hardware.
2. Locate the two x-pipe inlet adapters. Slide the adapters into the factory sleeve clamps, and tighten the clamps
using the ratchet and 15mm deep socket, until the adapters are snug in the clamps. (Fig. G)
3. Locate the double helixx x-pipe and two 3” clamps. Install the clamps on the driver and passenger x-pipe inlets
so that the bolt is vertical with the nut towards the ground and the bolts towards the outside of the vehicle.
(Fig. H) Slide the x-pipe inlets over the x-pipe adapter outlets. (Fig. I) Position the x-pipe so that the x-pipe
cross-brace located at the rear of the x-pipe is facing down and is parallel with the ground, and the x-pipe
outlets are centered around the rear differential. Tighten the clamps using the ratchet and 15mm deep socket
until the x-pipe is snug on the adapters. (Fig. J) Place a jack stand or similar device under the x-pipe for support.
4. Locate the passenger side hanger grommet assembly removed during step #5 of the stock exhaust removal
process along with the passenger side muffler assembly. Install the hanger grommet assembly onto the front
hanger of the muffler assembly in the same position as previously installed on the stock exhaust. (Fig. K)
NOTE: The use of a soap and water solution may aid in the installation of hanger grommets.
5. Locate one 3” clamp. Install the clamp on the passenger side muffler inlet pipe so that the bolt is vertical with
the nut towards the ground and the bolt is towards the inside of the vehicle. (Fig. L) Slide the rear hanger into
the rear hanger grommet located on the vehicle above and just inside of the passenger side tip cut out. (Fig. M)
Next, slide the muffler inlet pipe over the passenger side x-pipe outlet. (Fig. N)
NOTE: The use of a soap and water solution may aid in the installation of hanger grommets.
INSTALLATION INSTRUCTIONS CONTINUED ON NEXT PAGE