Owners manual
09/07/2016
INS5320
CORSA Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: (440) 891.0999 · F: (440) 891-1868
7
E - M a i l : s a l e s @ c o r s a p e r f o r m a n c e . c o m · w w w . c o r s a p e r f o r m a n c e . c o m
Exhaust System Installation
Axle Back Exhaust System
Dual Rear Exit w/ 4.5” Pro-Series Tips
2015 Ford Mustang GT 5.0L V8 Convertible
PN 14338(BLK) & 14339(BLK)
6. Tighten the clamp connecting the passenger muffler inlet pipe to the 3” adapter using the ratchet and 15mm
deep socket until muffler assembly is snug on the adapter. (Fig. T)
7. Repeat steps #3-#6 on the driver side of the vehicle.
8. Locate the passenger rear tip assembly and one 3” clamp. Install the clamp on the tip inlet pipe so that the bolt
is horizontal with the nut towards the inside of the vehicle and the bolt towards the top. Slide the tip assembly
over the muffler outlet pipe and tighten the clamp using the ratchet and 15mm deep socket until the tip
assembly is snug on the muffler outlet pipe. (Fig. U & V) Repeat this process for the driver side tip assembly
9. Locate the passenger side convertible brace and hardware removed during the stock exhaust removal process.
Side the front of the brace over the front bolt then install the furthest rear bolt to support the brace. Using a
3/8” drive ratchet and 13mm deep socket install the remaining bolts. Repeat this procedure for the driver side
brace. Tighten all bolts supporting the factory bracing to manufacture specifications. (Fig. W)
10. Adjust the system accordingly, including the adapter overlap on the stock exhaust, the rear muffler
depth and rotation, along with the tip depth and rotation so that the tips are centered in the bumper
valence. Rotate the tips so that the Corsa etch is on top with the tip rotation matching the slanted tip
cut out of the valance. (Fig. X) Check the position of all hangers to make sure they are properly
seated within their corresponding grommets. Check clearances between the system components and
chassis / convertible braces. At this time, tighten all clamps to 45ft-lbs using the torque wrench and
15mm socket.
NOTE: During cold weather start-ups, you may experience an exhaust sound that is deeper and
louder in tone than usual. This is temporary and will diminish to normal levels once your engine
has reached its normal operating temperature.
NOTE: Immediately following the installation of your exhaust system, you may experience a trace
of smoke after initial start-up. DO NOT be alarmed. The smoke is caused by the burning of a small
amount of forming oil residue used in the manufacturing process.
INSTALLATION PICTURES ON NEXT PAGE