Owners manual

INS5297
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
3
02/12/2018
[e-mail] l www.CORSAperformance.com
2015-2017 FORD MUSTANG GT 5.0L V8
3.0” Axle-Back Dual Rear Exit w/ Single or Quad Tips
Touring Part #: 14329 / BLK, 14336 / BLK - Sport Part #: 14326 / BLK, 14334 / BLK
CAUTION: Never work on a hot exhaust system. Allow the vehicle to cool for at least an hour and a half. Always wear eye
protection when working under a vehicle. It is recommended to use cotton gloves in order to protect stainless steel
surface of the header from permanent grease and oil stains.
REMOVAL INSTRUCTIONS
FACTORY EXHAUST
1. Starting on the driver side, measure 19 ¾” away from the flange on the stock resonator, following the
outside profile of the exhaust pipe. The tape measure should follow the bend profile of the pipe.
2. Measure 20” away from the flange on the stock
resonator, following the outside profile of the
exhaust pipe of the passenger side.
3. Using a chain cutter or similar device, cut both
the driver and passenger side exhaust pipes at
the marked locations. Place a jack stand or
similar device under the stock tunnel section of
the exhaust for support. Once the axle pipes are
cut, there are no additional stock hangers
supporting the tunnel section.
Continued on Next Page . . .