Owners manual
10. Repeat steps 6 to 9 above for the Driver side muffler (16CS2067 or 16CS2054).
11. Adjust the entire system as necessary to achieve the desired tips location and clearance to all driveline
components.
12. Starting from the front of the vehicle, tighten all Torca clamps to 45 ft.-lb.
13. It is STRONGLY SUGGESTED that all clamps and fasteners be checked and re-tightened (if necessary)
after a road test. Make sure the system has cooled prior to touching any exhaust components.
NOTE: During cold weather start-ups, you may experience an exhaust sound
that is deeper and louder in tone than usual. This is temporary and will
diminish to normal levels once your engine has reached its normal operating
temperature.
NOTE: Immediately following the installation of your CORSA exhaust
system, you may experience a trace of smoke after initial start-up. DO NOT
be alarmed. The smoke is caused by the burning of a small amount of
forming oil residue used in the manufacturing process.
CORSA Performance SPORT to TOURING CONVERSION KIT INSTALLATION:
NOTE: Be sure to save all nuts. These will be used to install your CORSA Performance exhaust system.
1. Using a 15 mm socket or wrench, remove the four front flange nuts (See Fig. A).
2. Using a 13 mm socket or wrench, remove the H-Pipe hanger nuts (See Fig. B).
3. Using a 15 mm socket or wrench, loosen the clamps connecting the H-Pipe to the Rear Muffler Assembly
(See Fig. C).
4. Slide the flanges off the bolts (See Fig. D).
5
CORSA Performance • 140 Blaze Industrial Parkway • Berea, Ohio 44017-2930 • P. 800.486.0999 • F. 440.891.1868
E-mail: sales@corsaperf.com • www.corsaperf.com
If you have any questions about the installation process, call CORSA Performance and ask one of our Sales
& Technical Service Representatives. Do not attempt to make any modifications to parts as this will void
your warranty.
Call 800.486.0999
FIG. A FIG. B
FIG. C FIG. D
T ORCA CLAMP
Position slot
90° off of bolt
Position
clamp at
end of
expanded
tube
INS5118 2/14/11
CONVERSION KIT INST ALLA TION
Technical Assistance:
(800) 486-0999