Owners manual

FIG. L
4
CORSA Performance • 140 Blaze Industrial Parkway • Berea, Ohio 44017-2930 • P. 800.486.0999 • F. 440.891.1868
E-mail: sales@corsaperf.com www.corsaperf.com
FIG. M
FIG. N
FIG. O
FIG. AB FIG. Y
FIG. W
INS5118 2/14/11
SPORT
Passenger Side
CORSA Performance SPORT EXHAUST INSTALLATION:
1. Remove all exhaust system components from the shipping carton, including clamps. NOTE: There are
two 2.5-inch clamps supplied.
2. Locate the Driver side (16CS4126) and Passenger side (16CS4113) axle pipes (See Fig. L & M).
3. Slide both Driver and Passenger axle pipes into position from the rear (See Fig. N).
4. Insert the axle pipes into the H-Pipe outlets and snug fit the clamps (See Fig. O). Note: If using
the factory H-Pipe, axle pipe will not bottom-out in the expansion. This is as designed.
5. Before installing the rear mufflers, cap both vacuum lines in the rear bumper with the supplied
rubber caps. If your vehicle is not equipped with a bimodal exhaust, you can dispose of these caps.
6. Locate the Passenger side muffler (16CS2068 or 16CS2053). Slide one Torca clamp onto muffler
inlet (See Fig. AB).
7. Slide the muffler hanger into the factory rubber isolators (See Fig. Y).
8. Carefully align the muffler inlet to the axle pipe.
9. Slide the axle pipe into the muffler inlet expansion and snug fit the Torca clamp using the 17-inch
extensions and a 15 mm socket (See Fig. W). NOTE: All the muffler clamps should point
towards the center of the vehicle when installed.