Owners manual
2
CORSA Performance • 140 Blaze Industrial Parkway • Berea, Ohio 44017-2930 • P. 800.486.0999 • F. 440.891.1868
E-mail: sales@corsaperf.com • www.corsaperf.com
FIG. B
FIG. A
FIG. C
FIG. D
FIG. E FIG. F
Exhaust Removal:
Your C6 must be raised high enough to remove the one-piece stock muffler and over-axle pipe assemblies.
A safe vehicle hoist is strongly recommended for this task.
NOTE: Be sure to save all nuts. These will be used to install your CORSA Performance exhaust system.
1. Using a 15 mm socket or wrench, remove the four front flange nuts (See Fig. A).
2. Using a 13 mm socket or wrench, remove the H-Pipe hanger nuts (See Fig. B).
3. Using a 15 mm socket or wrench, loosen the clamps connecting the H-Pipe to the Rear Muffler Assembly
(See Fig. C).
4. Slide the flanges off the bolts (See Fig. D).
5. Remove the H-Pipe assembly.
6. Using an 18 mm socket and a 15 mm open end wrench, remove the rear stabilizer bar mounting nuts (See
Fig. E). Both sides.
7. Use an 18 mm socket to remove the upper stabilizer bar mounting bolts (See Fig. F).
8. Swing the stabilizer bar down, away from the rear cradle.
INS5118 2/14/11
EXHAUST REMOVAL
Technical Assistance: (800) 486-0999