Owners manual

2
CORSA Performance • 140 Blaze Industrial Parkway • Berea, Ohio 44017-2930 • P. 800.486.0999 • F. 440.891.1868
E-mail: [e-mail] • www.corsaperf.com
FIG. G
CORSA Performance X-PIPE KIT INSTALLATION:
1. Remove all X-pipe Kit components from the shipping carton.
NOTE: There are two 2.5-inch clamps supplied.
2. Locate the X-pipe assembly, 16CS4013 OR 16CS4112,
(See Fig. E)
and the two Torca clamps.
3. Snug fit the clamps onto the outlets of the X-pipe assembly.
The clamps should be pointing towards the center of the vehicle.
4. Using a 13 mm socket or wrench, install the X-Pipe hanger nuts.
Tighten to factory specifications (See Fig. F).
5. Slide the flanges over the flange bolts and snug tighten the nuts
using a 15 mm socket (See Fig. G). The hanger bracket on the
X-pipe assembly should be pointing up.
6. Tighten the flange nuts to factory specifications.
7. Insert each axle pipe into the corresponding X-Pipe outlet (See Fig. H)
and tighten both clamps to 45 ft.-lb. NOTE: The CORSA Performance
X-pipe assembly is designed to work with any CORSA Performance
C6 Sport Exhaust System, but is not guaranteed to fit with every other
brand of exhaust system.
8. It is strongly suggested that all clamps and fasteners be checked and
re-tightened (if necessary) after a road test. Make sure the system
has cooled prior to touching any exhaust components.
INS5047 7/29/09
NOTE: Immediately following the installation
of your CORSA exhaust system, you may
experience a trace of smoke after initial start-
up. DO NOT be alarmed. The smoke is caused
by the burning of a small amount of forming
oil residue used in the manufacturing process.
TORCA CLAMP
Position slot
90° off of bolt
Position
clamp at
end of
expanded
tube
FIG. H
FIG. F
For technical assistance, call [phone].
FIG. E
(2) 2.5-inch clamps
X-pipe assembly
16CS4013 or 16CS4112