Owners manual

Tools Needed:
13 mm Socket
15 mm Socket
Torque Wrench
(20-100 ft.-lb.)
Safety Glasses
CORVETTE C6 X-PIPE
1
CORSA Performance • 140 Blaze Industrial Parkway • Berea, Ohio 44017-2930 • P. 800.486.0999 • F. 440.891.1868
E-mail: sales@corsaperf.com • www.corsaperf.com
INS5047 7/29/09
Corvette C6 X-Style Crossover Pipe (2005 & Up) PN 14163, 14127 & 14330
Exhaust System Installation
CAUTION: Prior to installation, be sure your vehicle is parked on a
level surface, and the exhaust system is cool. For safety purposes
and ease of installation, we urge you to take your vehicle to a qualified
service center or muffler installer that employs the use of a lift.
INSTALLATION NOTE:
Be sure to apply the provided anti-seize
lubricant to all bolts, fasteners and clamps. A pouch is included
with the hardware kit. Apply the supplied anti-seize lubricant to the
threads ONLY of all TORCA band clamps. Failure to follow this
procedure can cause the nuts to seize on clamps and potentially
damage threads. WARNING: Be sure to thoroughly clean hands
after use. Anti-seize lubricant will tarnish stainless steel parts.
Please be sure to review the attached
instructions prior to beginning the
installation process. If you have any
questions about the enclosed parts,
instructions or encounter a problem
during installation, call CORSA
Performance T
echnical Assistance at
800.486.0999. Do not attempt to make
any modifications to parts as this will
void your warranty.
FIG. A FIG. B
FIG. C FIG. D
For technical assistance call (800) 486-0999.
Exhaust Removal:
1. Using a 15 mm socket or wrench, remove the four front flange nuts
(See Fig. A). Be sure to save all nuts
- these will be used to install your CORSA Performance X-pipe assembly.
2. Using a 13 mm socket or wrench, remove the H-Pipe hanger nuts (See Fig. B). Be sure to save all nuts
- these will be used to install your CORSA Performance X-pipe assembly.
3. Using a 15 mm socket or wrench, loosen the clamps connecting the H-Pipe to the Rear Muffler Assembly
(See Fig. C).
4. Slide the flanges off the bolts (See Fig. D).
5. Remove the H-Pipe assembly.
All Torca clamps should be tightened using a properly calibrated Torque Wrench. Using an air impact gun will damage the
clamp and reduce its ability to effectively seal the joint. It may also cause the joint to separate thereby causing damage to
your exhaust system and your vehicle.