Owners manual

INS5352
140 Blaze Industrial Parkway, Berea, OH 44017 l P: 440.891.0999 F: 440.891.1868
2
7/5/2017
[e-mail] l corsaperformance.com
CORSA Tip Kit Installation
Please take time to read and understand these installation instructions.
CORSA recommends that the installation of this product be performed using the necessary equipment.
CAUTION: Never work on a hot exhaust system. Allow time for the vehicle to cool. Always wear eye protection
when working under a vehicle.
Recommended Tools:
 3/8” Drive 15mm Deep Socket
 Torque Wrench

 Safety Glasses
Please confirm that all parts are present before beginning the installation.
If something is missing call Tech Support at 440.891.0999 or Toll Free: 1.800.486.0999
WARNING! DO NOT SKIP!
Apply the anti-seize lubricant (supplied) to the threads
ONLY, of all the clamps and flange bolts. Failure to follow
this procedure can cause nuts to seize on clamps and
potentially destroy threads.
After applying anti-seize lubricant, be sure to thoroughly
clean your hands, as lubricant will tarnish stainless steel.
All clamps should be tightened using a properly
calibrated Torque Wrench to
45 ft-lbs
Using an air impact gun will damage the clamp and reduce its ability to effectively seal the joint. It may also
cause the joint to separate, thereby causing damage to your exhaust system and to your vehicle.
NOTE: Align all clamps so that the center of the clamp bolt is 90 degrees from the notch in the pipe.
It is STRONGLY SUGGESTED that all clamps be checked and re-tightened (if necessary) to the recommended
torque after initial road testing of the vehicle, as thermal cycling has occurred on the system.
Please wait until the system has fully cooled to perform this operation.