User's Manual

ISECUREtrac Corporation
?iSECUREtrac 2100NC User’s Manual Rev 1.0
Confidential Page 3 5/1/2002
FCC Requirements
1. The Federal Communications Commission (FCC) has established Rules Which permit this
device to be directly connected to the telephone network. Standardized jacks are used for these
connections. This equipment should not be used on party lines or coin phones.
2. If this device is malfunctioning and is causing harm to the telephone network… this device
should be disconnected until the source of the problem can be determined and until repair has
been made. If this is not done, the telephone company may temporarily disconnect service.
3. The telephone company may make changes in its technical operations and procedures. If
such changes affect the compatibility or use of this device, the telephone company is required to
give adequate notice of the changes. You will be advised of your right to file a complaint with the
FCC.
4. If the telephone company requests information on what equipment is connected to their lines,
inform them of:
a. The telephone number to which this unit is connected. End user phone number
b. The ringer equivalence number. 0.3
c. The USOC jack required. RJ 11C
d. The FCC Registration Number.
e. The FCC ID number is OAM2100NC
items (b), (d) and (e) are indicated on the label. The Ringer Equivalence Number (REN) is used
to determine how many devices can be connected to your telephone line. In most areas, the sum
of the REN's of all devices on any one line should not exceed five (5.0). If too many devices are
attached, they may not ring properly.
Service Requirements
In the event of equipment malfunction, all repairs should be performed by our Company or an
authorized agent. It is the responsibility of users requiring service to report the need for service to
our Company or to one of our authorized agents Service information can be obtained at
iSECUREtrac Corp.
5022 S. 114
th
Street
Suite 103
Omaha, NE 68137
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Note changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.