Specifications

Display Controller Installation
30
12. Turn on the display(s) and then your computer.
Turning on your system
If you have properly installed your graphics card, the Windows
start-up messages will appear once the boot procedure is
finished.
Note: Your Barco display(s) will be running in a basic video
mode at a default refresh rate. Higher resolutions and refresh
rates, such as 1536x2048@60Hz, are not available at this stage
of the installation. Once you have installed the B
ARCO CORONIS
Display System drivers and software, the Barco monitor Plug and
Play software should automatically set the resolution for the
displays.
13. Install the drivers, QAWeb software and documentation for your
B
ARCO CORONIS Display System by following the instructions in the
Driver and Software Installation section of this manual.
WARNING - Turn on your display(s) before you turn on
your computer. Failure to do so could damage your dis-
play(s).