User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting internal waveport CF parameters
- 3.1 Configuring functional parameters
- 3.2 Wake-up and synchronization
- 3.3 Configuring control parameters
- 3.3.1 Selecting RF communication mode
- 3.3.2 Selecting radio channel when FHSS is deselected
- 3.3.3 Selecting radio board transmission power
- 3.3.4 Activating RSSI threshold auto-correction
- 3.3.5 Selecting the serial baud rate
- 3.3.6 Reading Waveport CF firmware version
- 3.3.7 Reading RSSI
- 3.3.8 RSSI command format
- 3.3.9 TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
Waveport CF user manuel Coronis Systems
Appendix I – Waveport CF electronic interface
• Waveport CF
PIN # PIN NAME DESCRIPTION INPUT / OUTPUT
1 TX TX RS232 signal (0 ;+3Vmax) OUTPUT
2 RX RX RS232 signal (0 ;+3Vmax) INPUT
3 RESET RESET input (active to high level, min.: 100 ms) INPUT
4 OUT2 Not used OUTPUT
5 OUT1 Output active (level 1) when reception is on OUTPUT
6 GND Ground OUTPUT
7 +3V OUT 3V regulated output voltage (10mA available) OUTPUT
8
SUPPLY
VOLTAGE
Input supply voltage (3.3V to 4.5V)
Minimum current 45mA
INPUT
Compact_Flash-UserManual 65