User's Manual

File : CS-SUP-MUTI-WTHERMAPP-E01.sxw
APPENDIX A : SET OF THE APPLICATIVE COMMANDS
Applicative Commands Description
INTERNAL PARAMETERS SETTING
0x10 Request of parameter(s) reading
0x90 Acknowledgement of the request of parameter(s) reading
0x11 Request of parameter(s) writing
0x91 Acknowledgement of the request of parameter(s) writing
MODULES INFORMATION
0x20 Request to read the module type
0xA0 Response to the request to read the module type
0x28 Request of reading the firmware version (GET_FIRMWARE_VERSION)
0xA8 Response to the request of reading the firmware version
0x12 Request to read the date and time of the module
0x92 Response to request to read the date and time of the module
0x13 Request to set the date and time of the module
0x93 Response to request to set the date and time of the module
INFORMATION, CALIBRATION, AND INITIALIZATION OF THE SENSORS
0x04 Request to initialize the sensors
0x84 Response to the request to initialize the sensors
0x08 Request to calibrate the radio module (WaveTherm - PT100 et PT1000 only)
0x88 Response to the request to calibrate the radio module (WaveTherm - PT100 et PT1000 only)
0x16 Request to read the user data area
0x96 Response to the request to read the user data area
0x17 Request to write the user data area
0x97 Response to the request to write the user data area
READING THE INDEXES AND TABLES
0x01 Request to read the current temperature values
0x81 Response to the request to read the current temperature values
0x03 Request to read the datalogging storage table
0x83 Response to the request to read the datalogging storage table
0x05 Request to read the threshold detection table
0x85 Response to the request to read the threshold detection table
0x06 Request to read the storage table of the advanced datalogging
0x86 Response to the request to read the storage table of the advanced datalogging
0x07 Request to read the current ohmic value of the sensors
0x87 Response to request to read the current ohmic value of the sensors
ALARM FRAMES MANAGEMENT
0x23 Request to configure the alarms to be sent
0xA3 Acknowledgement of the request
WaveTherm modules – application handbook page 65 of 65