User's Manual

File : CS-SUP-MUTI-WTHERMSPETEC-E02.sxw
3 INSTALLATION OF A WAVETHERM MODULE
WaveTherm module installation is carried out by connecting the temperature measurement probes to the
module. (in general, the modules are supplied with the probes pre-wired)
3.1 MODULE FASTENING
Two diagonally opposed holes enable easy screw fastening of the module to a flat surface.
The specially designed casing of the WaveTherm module may be fastened to a pipe (the rear surface of the
module is vertically curved) and secured with clamping or fastening straps (a horizontal guide is incorporated
in the front surface for this purpose).
3.2 INSTALLATION PRECAUTIONS
To ensure optimum operation, both from a battery as well as a radio frequency emission point of view, it is
recommendable to fasten the WaveTherm module vertically with the aerial pointing up and to ensure a
minimum distance of 20 cm between two modules.
It is also recommendable to install the modules, whenever possible, far away from metal surfaces and
electrical cables.
WaveTherm module technical specifications page 17 of 31
Two diagonally opposed holes enable easy screw
fastening of the module to a flat surface.