User's Manual
Table Of Contents
- 1.Definitions
- 2.Introduction
- 3.Reference documents
- 4.RTM Elster AMCO Configuration access
- 5.RTM Elster AMCO functionalities
- 5.1.Fixed Network/Walk By/ Drive By switching method
- 5.2.Datalogging management
- 5.3.RTM-Register interface
- 5.4.RTM-register pairing
- 5.5.RTM reading management
- 5.6.Automatic Radio transmission (pseudo bubble up mode - Fixed Network Only)
- 5.7.Leak detection management
- 5.8.Tamper detection (pulse register only)
- 5.9.Communication and reading error detection (encoder only)
- 5.10.Low Battery Warning detection
- 5.11.Faults or Flow Problems automatic transmission
- 6.Radio address description
- APPENDIX : SERVICE COMMANDS
RTM Elster AMCO applicative PFS Coronis Systems
4.RTM Elster AMCO Configuration access
RTM Elster AMCO as several embedded features, each one detailed later in this document, that are fully
configurable using radio frames. This section describes radio frame generic format and explains how to
access to the configuration of each embedded feature.
4.1.Radio exchange principle
Figure 1 below shows a point-to-point radio exchange principle between a USB Waveport (Waveport is a
Coronis radio modem generally used as the initiator of the radio exchange) and a Standard Coronis RTM.
Figure 1
sEVO RTM-UserMan-E02 8
RTM
Elster
AMCO