User's Manual
Table Of Contents
- 1.Definitions
- 2.Introduction
- 3.Reference documents
- 4.RTM Elster AMCO Configuration access
- 5.RTM Elster AMCO functionalities
- 5.1.Fixed Network/Walk By/ Drive By switching method
- 5.2.Datalogging management
- 5.3.RTM-Register interface
- 5.4.RTM-register pairing
- 5.5.RTM reading management
- 5.6.Automatic Radio transmission (pseudo bubble up mode - Fixed Network Only)
- 5.7.Leak detection management
- 5.8.Tamper detection (pulse register only)
- 5.9.Communication and reading error detection (encoder only)
- 5.10.Low Battery Warning detection
- 5.11.Faults or Flow Problems automatic transmission
- 6.Radio address description
- APPENDIX : SERVICE COMMANDS
RTM Elster AMCO applicative PFS Coronis Systems
5.11.1.Time windows dedicated to alarm sending.................................................................................27
5.11.2. Automatic configuration of the destination route (via SDP)........................................................27
6.RADIO ADDRESS DESCRIPTION..............................................................................................................28
APPENDIX : SERVICE COMMANDS.............................................................................................................29
Wavecard Serial Link Service Request Command description.......................................................................29
Request types.................................................................................................................................................30
sEVO RTM-UserMan-E02 3