User's Manual
Table Of Contents
- 1.Definitions
- 2.Introduction
- 3.Reference documents
- 4.RTM Elster AMCO Configuration access
- 5.RTM Elster AMCO functionalities
- 5.1.Fixed Network/Walk By/ Drive By switching method
- 5.2.Datalogging management
- 5.3.RTM-Register interface
- 5.4.RTM-register pairing
- 5.5.RTM reading management
- 5.6.Automatic Radio transmission (pseudo bubble up mode - Fixed Network Only)
- 5.7.Leak detection management
- 5.8.Tamper detection (pulse register only)
- 5.9.Communication and reading error detection (encoder only)
- 5.10.Low Battery Warning detection
- 5.11.Faults or Flow Problems automatic transmission
- 6.Radio address description
- APPENDIX : SERVICE COMMANDS
RTM Elster AMCO applicative PFS Coronis Systems
5.6.Automatic Radio transmission
(pseudo bubble up mode - Fixed Network Only)
(Refer to DR[3] Section 1.0.20)
RTM Elster AMCO is able to send periodically some of its information through the network. This feature is
fully configurable. Pseudo bubble up like system configuration and activation is made with a single radio
frame.
ATTENTION:
In evoHop profile case, the only allowed command is 0x01. It allows to get generic header informations.
sEVO RTM-UserMan-E02 22