User's Manual

RTM Elster AMCO applicative PFS Coronis Systems
5.5.3.Datalogging table reading
First of all, it is important to note that only the last logged reading is time stamped. So, CORONIS advises to
read datalogging table from the last logged reading in order to be able to compute the time stamp of each log.
ATTENTION :
Datalogging table reading is not available in evoHop Elster AMCO profile.
Note:
When the number of requested logged reading is higher than the number of reading effectively logged, then
RTM Elster AMCO returns the whole datalogging table.
This behavior is always true excepted in case of “Drive By/Walk By” mode, in this case only 36 logged
readings per port can be read out.
ATTENTION:
1) When RTM Elster AMCO is programmed in Fixed Network mode operation and datalogging
reading in pseudo bubble-up is parametrized, it is advised to use the table above to select the
appropriate number of expected logged reading per port. Indeed, if the number of expected
logged reading is too large and so multiframe radio process is used, the behavior of the pseudo
bubble-up mechanism in the whole network will be affected and will lead to a loss of information
coming from th RTM.
2) When RTM Elster AMCO is configured in Drive By / Walk By mode, Datalogging table reading is
limited to the last 36 logs per port.
sEVO RTM-UserMan-E02 20