User's Manual
Table Of Contents
- 1.Definitions
- 2.Introduction
- 3.Reference documents
- 4.RTM Elster AMCO Configuration access
- 5.RTM Elster AMCO functionalities
- 5.1.Fixed Network/Walk By/ Drive By switching method
- 5.2.Datalogging management
- 5.3.RTM-Register interface
- 5.4.RTM-register pairing
- 5.5.RTM reading management
- 5.6.Automatic Radio transmission (pseudo bubble up mode - Fixed Network Only)
- 5.7.Leak detection management
- 5.8.Tamper detection (pulse register only)
- 5.9.Communication and reading error detection (encoder only)
- 5.10.Low Battery Warning detection
- 5.11.Faults or Flow Problems automatic transmission
- 6.Radio address description
- APPENDIX : SERVICE COMMANDS
RTM Elster AMCO applicative PFS Coronis Systems
5.5.RTM reading management
(Refers to DR[3] Section 1.0.22; DR[4,5] Section 1.0.19)
RTM Elster AMCO offers the possibility to recover different types of readings listed below:
➢ Current reading,
➢ Daily consumption profile readings,
➢ Datalogging table,
➢ TOU buckets.
These different way to recover reading from RTM Elster AMCO are described in details in this section.
Furthermore, RTM Elster AMCO sends back on each of these requests, control information formatted as a
generic header described below. This one is useful to manage network supervision.
5.5.1.Current register reading
When current index reading is expected, RTM Elster AMCO sends back through a radio frame the current
readings on each Port connected. If a Port has no meter connected to it, then the corresponding current
reading is set to 0x7FFFFFFF.
5.5.2.Daily consumption profile reading
Daily consumption profile reading request allows to recover:
➢ generic header,
➢ current readings,
➢ logged readings 4th, 8th, 12th, 16th, and 20th positions in the datalogging table (if
datalogging is set).
ATTENTION :
Daily consumption profile reading is not available in evoHop Elster AMCO profile.
ATTENTION:
Daily consumption profile is accurate only when datalogging every hour is programmed.
All other datalogging configuration will not provide daily information using this particular
command.
sEVO RTM-UserMan-E02 19