User's Manual
Table Of Contents
- 1.Definitions
- 2.Introduction
- 3.Reference documents
- 4.RTM Elster AMCO Configuration access
- 5.RTM Elster AMCO functionalities
- 5.1.Fixed Network/Walk By/ Drive By switching method
- 5.2.Datalogging management
- 5.3.RTM-Register interface
- 5.4.RTM-register pairing
- 5.5.RTM reading management
- 5.6.Automatic Radio transmission (pseudo bubble up mode - Fixed Network Only)
- 5.7.Leak detection management
- 5.8.Tamper detection (pulse register only)
- 5.9.Communication and reading error detection (encoder only)
- 5.10.Low Battery Warning detection
- 5.11.Faults or Flow Problems automatic transmission
- 6.Radio address description
- APPENDIX : SERVICE COMMANDS
RTM Elster AMCO applicative PFS Coronis Systems
5.4.4.Encoder model detection
(Refers to DR[3] Section 1.0.17; DR[4,5] Section 1.0.16)
RTM Elster AMCO embeds a feature allowing to recognize the encoder model connected.
This feature is performed either when profile selection parameter is programmed with encoder profile value,
or using a dedicated radio command.
RTM Elster AMCO run all encoders drivers and recognizes the connected encoders models.
Once the initialization is completed, RTM Elster AMCO sends back to the command initiator the encoder
model.
Note :
This command has to be performed once the RTM is connected to the encoder, either in the field during
installation phase or during manufacturing phase of the RTM.
5.4.5.Encoder Unit (Encoder register only)
Each encoder embeds its unit in an internal parameter and the RTM Elster AMCO reads out this information
after encoder model detection. It stores the unit inside a read only parameter.
The unit parameter contains two important information that are the position of the decimal point and the unit.
ATTENTION:
the unit value will only be given for informative purpose. RTM Elster AMCO does not convert the current
unit to a standard GALLON unit and all operations are processed without taking into account the unit and
the decimal point position, it is up to the user software to convert the information in desired unit.
sEVO RTM-UserMan-E02 18