User's Manual
Table Of Contents
- 1.Definitions
- 2.Introduction
- 3.Reference documents
- 4.RTM Elster AMCO Configuration access
- 5.RTM Elster AMCO functionalities
- 5.1.Fixed Network/Walk By/ Drive By switching method
- 5.2.Datalogging management
- 5.3.RTM-Register interface
- 5.4.RTM-register pairing
- 5.5.RTM reading management
- 5.6.Automatic Radio transmission (pseudo bubble up mode - Fixed Network Only)
- 5.7.Leak detection management
- 5.8.Tamper detection (pulse register only)
- 5.9.Communication and reading error detection (encoder only)
- 5.10.Low Battery Warning detection
- 5.11.Faults or Flow Problems automatic transmission
- 6.Radio address description
- APPENDIX : SERVICE COMMANDS
RTM Elster AMCO applicative PFS Coronis Systems
5.2.2.Datalogging in time steps
This type of datalogging is used to log the readings for each port at periods ranging from one minute to over
thirty hours.
Parameter :
measurement period of the datalogging in time steps : expressed as a multiple of the reading
sampling period (parameter 0x07). (from 1 minute to 31h30minutes)
5.2.3.Datalogging once a week
This type of datalogging is used to log the readings for each Port once a week. The time, and day
of the week, logging is carried out, may be set with a parameter.
Parameters :
Time of measurement (datalogging once a week) : this parameter allows to synchronize the
periodic measurement on RTM Elster AMCO RTC. It is expressed in multiple of hour, and its
value must be set from 0 to 23.
Day of the week (datalogging once a week) : this parameter allows to select the day of week.
5.2.4.Datalogging once a month
This type of datalogging is used to log the readings for each Port once a month. The time and day
(from 1 to 28) logging is carried out may be set with a parameter.
Parameters :
Time of measurement (datalogging once a month) : this parameter allows to synchronize the
periodic measurement. It is expressed in multiple of hour, and its value must set from 0 to 23.
Day of the month (datalogging once a month) : the format is different from the datalogging
once a week. Indeed, the day of measurement is set from 1 to 28. And, the system does not
manage changes in the number of days depending on the month (day of the month setting cannot
exceed the 28
th
).
sEVO RTM-UserMan-E02 14