User's Manual
Table Of Contents
- 1.Definitions
- 2.Introduction
- 3.Reference documents
- 4.RTM Elster AMCO Configuration access
- 5.RTM Elster AMCO functionalities
- 5.1.Fixed Network/Walk By/ Drive By switching method
- 5.2.Datalogging management
- 5.3.RTM-Register interface
- 5.4.RTM-register pairing
- 5.5.RTM reading management
- 5.6.Automatic Radio transmission (pseudo bubble up mode - Fixed Network Only)
- 5.7.Leak detection management
- 5.8.Tamper detection (pulse register only)
- 5.9.Communication and reading error detection (encoder only)
- 5.10.Low Battery Warning detection
- 5.11.Faults or Flow Problems automatic transmission
- 6.Radio address description
- APPENDIX : SERVICE COMMANDS
RTM Elster AMCO applicative PFS Coronis Systems
5.RTM Elster AMCO functionalities
5.1.Fixed Network/Walk By/ Drive By switching method
(Refers to DR[5] Section 1.0.1)
According to §4.3.2 (Operating mode parameter description), RTM Elster AMCO is able to operate in “Fixed”
network, “Walk By”, and “Drive By” installations. The operation in “Walk By” and “Drive By” is exactly the
same.
RTM Elster AMCO operating in “Fixed” network mode just needs a setting command coming from a hand-
held computer to switch in “Drive By” mode operation. Conversely, once operating in “Drive By” (or in “Walk
By”), only a new setting command in WalkBy is required to make it switching in “Fixed” Network mode
operation.
Parameters details :
WakeUp Channel :
This parameter allows to define the channel number used by the RTM to receive in DriveBy/WalkBy mode.
Emission Number :
This parameter allows to define the number of emissions made by the RTM in response to a DriveBy
WakeupTone reception.
Inter-Answer Delay :
This parameter allows to define the delay the RTM should wait between 2 answers to a DriveBy
WakeupTone.
The format is : 0xhhmmss : hh = hours number, mm = minutes number, ss = seconds number.
The maximum allowed delay is 255 hours + 255 minutes + 255 seconds and the minimum is 1 second.
This delay include the frames sending.
Minimum RSSI :
This parameter defines the minimum RSSI Level required on a DriveBy WakeupTone to answer.
ATTENTION :
DriveBy/WalkBy mode is not available in evoHop Elster AMCO profile.
sEVO RTM-UserMan-E02 12