User's Manual

RTM Elster AMCO applicative PFS Coronis Systems
4.2.4.Leakage Detection Status
This control byte is used to detect leakage in real time. Indeed, each bit is set to one when a leakage is
detected and reset to zero automatically when it ended. This information can be read by the standard read
parameter command. This parameter is in read access only.
ATTENTION :
Leakage detection is not available in evoHop Elster AMCO profile.
4.3.Meter reading sampling period configuration
Several RTM Elster AMCO embedded features (datalogging in time steps, leakage detection, back flow
detection) are based on periodic reading management. So, in order to synchronize these features RTM
Elster AMCO offers the possibility to program a kind of “Meter Reading Sampling Period” principle that is
shared between the features listed above in parenthesis.
ATTENTION :
1) Meter sampling reading management starts only on associated feature activation (datalogging in
time steps, back flow or leakage detection). This allows to avoid power consumption (especially
when encoder profile is selected) while no periodic sampling is necessary. Once one of this
associated feature is activated, the sampling will start on nex hour “on the dot”.
2) Each meter reading sampling period parameter modification must be followed by a user
initialization of all the associated features (datalogging in time steps, back flow or leakage
detection).
ATTENTION :
Meter reading sampling period is not available in evoHop Elster AMCO profile.
sEVO RTM-UserMan-E02 11