User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting the internal parameters of the wavecard
- 3.1- Configuration of the functional parameters
- 3.2- Configuration of the control parameters
- 3.2.1 - selection of the radio operating channel when FHSS is deselected
- 3.2.2 - Selection of the RF medium physical mode
- 3.2.3 - Selection of the radio board emission power
- 3.2.4 - Activation of the Wavenis RF Asic RSSI threshold autocorrection
- 3.2.5 - Selection of the serial baudrate.
- 3.2.6 - Reading the firmware version of the WaveCard
- 3.2.7 - Reading the RSSI level (Received Signal Strengh Indicator)
- 3.2.8 - TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
- 5.1- 'Frame Exchange’ Mode
- 5.2- 'Message’ Mode
- 5.3- ’Polling’ Mode
- 5.4- ’Broadcast’ mode
- 5.4.1 - Configuration of the parameters relating to the 'Broadcast' mode
- 5.4.2 - 'BroadCast' mode without waiting for a response
- 5.4.3 - 'BroadCast' mode with waiting for responses
- 5.4.4 - Format of the commands – from the request transmitter side
- 5.4.5 - Format of the commands – from the request receiver side
- 5.4.6 - Use of the selective, or not-selective broadcast mode
- 5.5- ’Multi frames' Mode
- 6. ANTENNA
Document : EvoModule1- UserMan.sxw
In 'relaying' mode
RECEPTION_ERROR
HEADER CMD DATA CRC ETX
3 bytes 1 byte 1 byte 1 byte 1 byte 2 bytes 1 byte
0xFF ;
0x02 ;
0x06
0x31
EXCHANGE_MODE :
= 0x02 : relaying mode
0x02
Default value for
relaying mode
RELAY_COUNTER :
= 0x03 No response from the third repeater;
= 0x02 No response from the second repeater;
= 0x01 No response from the first repeater;
= 0x00 No response from the final equipment.
0x03
Note: In the MESSAGE mode, the error frame intervene only between the transmitter, and the first
repeater. Even if the other repeaters return errors, the transmitting module does not await an answer, and
proceeds to another action.
In both cases, the procedure of sending an error frame depends on parameter RADIO_ACKNOWLEDGE:
If RADIO_ACKNOWLEDGE is active, and the transmitter does not receive a radio
acknowledgement, then the request is re-emitted three times, before sending the error frame.
If RADIO_ACKNOWLEDGE is inactive, then the error frame is sent after time-out
RADIO_USER_TIMEOUT.
EvoModule1 Handbook page 48 of 68