User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. RS232 SERIAL PROTOCOL PRESENTATION
- 3. setting the internal parameters of the wavecard
- 3.1- Configuration of the functional parameters
- 3.2- Configuration of the control parameters
- 3.2.1 - selection of the radio operating channel when FHSS is deselected
- 3.2.2 - Selection of the RF medium physical mode
- 3.2.3 - Selection of the radio board emission power
- 3.2.4 - Activation of the Wavenis RF Asic RSSI threshold autocorrection
- 3.2.5 - Selection of the serial baudrate.
- 3.2.6 - Reading the firmware version of the WaveCard
- 3.2.7 - Reading the RSSI level (Received Signal Strengh Indicator)
- 3.2.8 - TEST Mode
- 4. SERVICE COMMANDS
- 5. COMMUNICATION MODES
- 5.1- 'Frame Exchange’ Mode
- 5.2- 'Message’ Mode
- 5.3- ’Polling’ Mode
- 5.4- ’Broadcast’ mode
- 5.4.1 - Configuration of the parameters relating to the 'Broadcast' mode
- 5.4.2 - 'BroadCast' mode without waiting for a response
- 5.4.3 - 'BroadCast' mode with waiting for responses
- 5.4.4 - Format of the commands – from the request transmitter side
- 5.4.5 - Format of the commands – from the request receiver side
- 5.4.6 - Use of the selective, or not-selective broadcast mode
- 5.5- ’Multi frames' Mode
- 6. ANTENNA
Document : EvoModule1- UserMan.sxw
REVISIONS HISTORY
Rev. # Description Auteur Date Commentaires
1 Original document PGN 19/09/08 Version 1
2 updated PGN 11/06/08 version2
➢ FIRMWARE VERSIONS OF SUPPORTED WAVECARD INTEGRATED INTO
THE EVOMODULE1
WaveCard 500mW : Compatible with the version v4.01, and later
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions : this device may not cause harmful interference, and
this device must accept any interference received, including interference that
may cause undesired operation.
Caution : any changes or modifications not expressly approved by Coronis-
Systems could void the user's authority to operate the equipment.
EvoModule1 Handbook page 2 of 68