Manual

t2.While still holding
the WiCk Assembly up.
aide-Qown, grasp the
WiCk Cover firmly and
PULL it oft with a sharp
tug.
13. Remove t_le W_ck
while folding _t to t_e
_nside
Remove the Wick S_eeve
to(JeThef wrth the Wtck
14, Insert the Wick pins __
into three holes of the
(Position the "t UP'
marking of the WiCk
Sleeve in the upward
direction of the W_Ck
and attach.)
15. Atl_ch the Wick So
that the retainer teeth
of the Wick Sleeve stick
into it, fitting the Wick
evenly around the inside
tO avoid wrinkles
16. While pressing each
of the three pins of the
Wick (attached to the
Wick sleeve) toward
the inside, insert the
three Pies into the slan-
ted grooves Of the Wick
Guide. Press on each of the three pros, inserting
them securely in the hOleS
NOTE: Turn the Wick Adjustment Knob and check
that th_ VV_Ck moves up and down
17. The wick height wile automaticaNy be set to the
correct burning height of 3/8"(1Orate).
lB. Turn the Wick As-
sembly upside down to
l'eplace the Wick Cover.
lg. Align the four tabs on the Wick Cover with the four
screw holes on the Bottom of the Assembly, as shown,
ae_ snap it into place Be certain Of firm contact at
all points Place the arrow or_ the Wick Cover to the
front
;tO. Hold the S_t Lever {o down posthon by hriger
23, While your heater is disassembled, CheCk the
Automatic Shut-off System
"i>4. Trip the Automatic
Shut off System by
r_udging the Brass Pen-
dulum, Reset the Sy-
stem by pressing the
Set Level DOWN Trip it
again to make certaim it
25. Turn the Wick Adiustment Knob to test its operation.
Be certain the Wick operates Smoothly as the Knob is
turned CLOCKWtSE and COUNTER-CLOCKWrSE
26. Test Ignition. Rahse the Wic_ to its full height. The
Ignition Plug _hould be within ?." to y=." (1 mm to 2ram) of
the Wick when the Lever is fully depreSs_.
27. Remove Wtck Adiugtment Koob which you had tern
por_rily repla_ed tO test WiCk operation
_8. Replace the D_essing Plate making certain to allgn
the Aotomat_¢ S_t.off System Lever and lhe Wick
Adjustment ROd, which hoId_ the Knob, with the app_o.
priafe stots in the Dress,rig Plate Begin by aligning them
ahd gently Snap the D_'esslng Ptate it1 place over the
V_ick Assembly
:29. Replace the heater Cabinet Make certain the Grille
Guard prongs _re inserte_ _eeurely into the prope_ boles
On the h_ater, and tP_e Cabinet Fro_t matches the froni
OI the heater
30. Fasten the Cabins{ to the heater with the two
screws
31, Replace the Wick
"-_ll I Adjustment Knob. To
be certain it is properly
positioned on the Wick
Ad_iustment Shaft, raise
- _ the Wick !O its full
height The mark om the
knob must llne up with the word "HtGH"On the cOntrOl
panel