Technical data
9
With your hands griping under the control panel slide, the
range forward to disengage from the anti-tip bracket.
Reverse procedure to reinstall. If gas line has been
disconnected, check for gas leaks after re-connection.
NOTE: A qualified person should disconnect and reconnect
the gas supply.
The service engineer MUST follow installation instructions
provided with the gas appliance connector and the warning
label attached to the connector.
CAUTION: DO NOT USE A FLAME TO CHECK FOR GAS LEAKS.
When using test pressures greater than ½ psig (3.5kPa)
to pressure test the gas supply system of the residence,
disconnect the range and individual shut-off valve from
the gas supply piping. When using test pressures of ½
psig (3.5kPa) or less to test the gas supply system, simply
isolate the range from the gas supply system by closing the
individual shut-off valve.
If the range is removed for any reason, make sure the anti-tip
device is re-engaged properly when the range is replaced.
Failure to take this precaution could result in tipping of the
range and cause injury.
To replace the drawer in the range, pull the side rails fully out
Fig. 3-4. Carefully move the drawer back between the rails
and rest it on the side rails. At each side hold the front of the
drawer and pull the side rail forward so that the clips click
into position holding the drawer to the side rails Fig. 3-5.
Disconnect the range from the electricity supply.
Remove cooktop grids and burner heads Fig. 4-1.
Undo the large brass nuts and remove the brass venturis
using a 22mm socket Fig. 4-2.
Lift up the front of the cooktop
top and disconnect the ignition leads from the electrodes
and earth lead. Lift the cooktop clear of the range. Replace in
reverse order.
Remove all the control knobs. Open oven door. Remove the
4 screws on oven beak. Remove the 3 screws on the control
panel underside and 3 screws on the top front. Pull the
control panel forward Fig. 5-1.
Remove the connections from the rear of the neon and light
switch. Lift the panel clear of the range.
Replace all parts in reverse order.
When replacing any electrical connections refer to the wiring
diagram.
ArtNo280-0085 Refitting Drawer
ArtNo.280-0021 - Drawer Locking
ArtNo281-0109 Burner Venturi