Technical data
8
Turn off the power at the circuit breaker.
Make sure the oven is cool. Open the oven door and remove
the oven racks.
Unscrew the bulb cover by turning counter clockwise. It may
be very stiff Fig.1-1.
Taking care to protect your fingers in case the bulb should
shatter, unscrew the old bulb.
Screw in the new bulb, screw back the bulb cover. Turn on the
circuit breaker and check that the bulb now lights.
Replacement bulb must be 15w 125-130v lamp, FOR OVENS,
heat resistant to 300°C (570°F).
Follow these procedures to move the range for servicing:
Shut off the gas supply and disconnect electrical supply to
appliance. Disconnect gas supply tubing to appliance and
unplug the electrical supply cord. (Note: These areas may be
more easily accessible once the storage drawer is removed).
NOTE: A qualified person should disconnect and reconnect
the gas supply.
The range is very heavy. Please assess any risks associated
with moving. You may require a protective floor covering to
prevent any possible damage. Ensure that the floor covering
is firmly attached to prevent it being disturbed when moving
the range around. You will need the levelling tool.
Pull the drawer out to its furthest point and empty it Fig. 2-1.
Lift up the ends of the plastic clips (one each side) to release
the catches holding the drawer to the side runners and at the
same time pull the drawer forward and away from the side
runners Fig. 2-2.
For safety’s sake push the drawer runners back out of the way.
Put the drawer somewhere safe - do not refit it until you have
finished, you will need access to the area behind the drawer.
To remove the door, open the door fully. Swivel the locking ‘U’
clips forward to the locking position Fig. 3-1. To remove the
oven door, grip the sides of the door, lift upwards and then
slide the door forward Fig. 3-2.
When you have removed the oven door, continue as follows:
Lower the two rear rollers.
First use the levelling tool to turn the hexagonal adjusting
nut and make 10 complete 360° turns clockwise. (This means
turning and removing the levelling tool 20 times) Fig. 3-3.
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the range.
The appliance can be lifted/moved by gripping the top of the
oven cavity once the door is removed.
Do not replace the storage drawer yet.
ArtNo.281-0139 - Drawer clip lift
ArtNo.341-0001 - 90SC - Drawer pulled forward
ArtNo.010-0010 Lowering the rear rollers (90)
x10
ArtNo.281-0017 - Removing the door