Technical data
3
Open the oven door and turn on the oven lights
One bulb does not
work
Light bulb failed (most likely cause)
Both lights do not
work
No power to range
Fault in power supply to switch on facia
Faulty switch
In line switch problem
Remove the light bulb. Check the bulb resistance with a meter and replace it if necessary.
If the bulb is OK then move the range forward and remove the rear cover.
With the meter check the continuity of the wiring to the bulb and the action of the switch. Replace wiring or switch
as necessary.
Turn the function control to the Defrost setting
and check that the oven fans start to spin.
Fan(s) do not spin
Fault in power supply to switch
Faulty switch
Fault in power supply to fan
Fan motor faulty
Fan blades impeded
Remove the oven inner back and check that the fan is not impeded.
If not then move the range forward and remove the rear cover.
With the meter check the continuity of the wiring to the fan and the action of the switch. Replace wiring, switches
or fan as necessary.
Remove the oven racks. Turn the oven
temperature control to 400F and turn the function
control to each setting in turn and check that the
elements start to heat up. See the chart opposite.
You should be able to feel the heat from the
element after few moments by holding your
hand close to the element (DON’T TOUCH THE
ELEMENTS!).
The bottom elements may take slightly longer to
heat up.
Turn the controls off when you have finished.
One element does not
heat up
Burnt out element (most likely cause)
Faulty switch
Fault in power supply to element
No element heats up
Faulty oven thermostat (most likely cause)
Faulty switch
Fault in power supply to elements
Remove the element and check it with a meter. Replace with a new element if necessary.
If the element is OK then move the range forward and check the continuity of the wiring
and the function switch.
Remove the range cooktop
and check the thermostat and
function switch
TROUBLESHOOTING - CHECKING THE OVEN