Technical data
14
ArtNo 281-0149 - USA oven fan element
Open the oven door. For the right hand side unscrew the 4
thermostat phial fixing screws Fig. 22-1.
Remove the fixings that secure the inner back to the oven
rear. Lift the removable panels away.
Re-assemble in reverse order. Ensure that the retaining fixings
are fully tightened.
Disconnect the range from the electricity supply.
Pull the range forward to access the cover boxes at the rear
of the range, see the section ‘How To Move the Range for
Servicing’ (page 8).
Remove the inner back.
Hold the fan blades and undo the centre nut (LH thread),
brass washers, fan blade and circlip Fig. 23-1.
Undo the screws that retain the fan and remove it from the
cavity rear.
Fit the replacement and re-assemble parts in reverse order.
Check that the oven operates satisfactorily.
Disconnect the range from the electricity supply.
Remove the inner back.
Remove the screws that secure the element within the oven
and lift the element away carefully Fig. 24-1.
Disconnect the leads and connect to the replacement
element and re-assemble parts in reverse order.
Disconnect the range from the electricity supply.
Pull the range forward to access the cover boxes at the rear
of the range, see the section ‘How To Move the Range for
Servicing’. Remove the fixings that secure the cover and lift it
clear.
Remove the 2 screws ‘A’ and allow the plate to drop down.
Remove the 2 screws B, lower the upper plate and remove
through the slot in the range back Fig. 25-1.
Undo the terminal connections, noting their positions.
Remove the element fixings and withdraw element. Replace
the element and re-assemble parts in reverse order.
Remove the top element bracket fixings and withdraw
elements carefully lifting to clear the clips on the support bar
Fig. 25-2.
Replace the element and re-assemble parts in reverse order.
Check that the oven operates satisfactorily.