Technical data

13
ArtNo.281-0017 - Removing the door




Place the outer panel on a clean flat surface.
The door trim handle plate is held in place by screws on the
inside. Studs and nuts hold the other trims Fig. 17-2.
Replace the damaged parts and re-assemble in reverse order.
 
The door inner panel is supplied.
Remove the door.
Carefully place the door, outer side up, on a clean level
surface. Remove the hexagon headed screws.
 
Open oven door. The seal is held in place by small hooks to
the range front. At the corner pull seal diagonally away from
the door centre until that hook is released.
Proceed to the next hook and release it in a similar way, and
so on. Use force if the hooks are stiff, as the old seal will be
discarded.
When fitting new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door, and
proceed round the door snapping in each hook in turn
Fig. 19-1.
 
Remove cooktop. Unclip the spark generator by first sliding
right then lift left hand side and pull forward. Remove the
wiring ensuring the wires are assembled in the same position
in new generator Fig. 20-1.
 
Remove the cooktop grids, cooktop accessories and burner
heads.
Lift up the front of the cooktop and prop it up.
Disconnect the leads at the electrodes and generator. Replace
with new leads.
Re-assemble in reverse order and check ignition.