Technical data
12
Disconnect the range from the electricity supply.
Remove pan support and burner head. Undo the large brass
nut and remove the brass venturi. Lift up the burner base and
disconnect the ignition lead from the electrode. The orifice is
now accessible using a 7mm box spanner.
Alternatively, remove the cooktop. Remove the orifice directly
from the burner body. Fit the appropriate orifice Fig. 14-1.
Re-assemble in reverse order. Check the range is gas sound.
Disconnect the range from the electricity supply. Remove the
cooktop grids, cooktop accessories and burner heads.
Undo the bezel venturi and remove the bezel from the
cooktop. The spark ignition wire will be pulled through the
electrode clearance hole Fig. 15-1. Disconnect the spark
electrode from the ignition wire.
Take care to prevent the ignition wire from falling back
through the clearance hole. Undo the spark electrode from
the bezel by removing the spring clip and spring. Fit the
replacement electrode to the burner bezel. Ensure that the
spring and clip are properly located. Replace in reverse order
and check correct burner ignition.
Remove the cooktop grids, cooktop accessories and burner
heads. Remove the cooktop.
Remove the nut that secures the burner body to the support
channel. Remove the fixings that secure the support channel
to the chassis. Lift the channel clear of the range Fig. 16-1.
Undo the compression fitting which connects the burner
body to the gas pipe. Remove the burner body from the
range.
Replace in reverse order. Check the range is gas sound and
that the burner operates satisfactorily.
The door outer panel and all the trim parts are available as
separate spares so that individual parts can be changed.
Door is very heavy - take care.
Unscrew the door handle and remove the handle and door
trim handle disk Fig. 17-1.
ArtNo.281-0128 - Burner support bracket
ArtNo.281-0129 - Cooktop
burner orifice assy
ArtNo.281-0118 - Electrode spring