User's Manual

Voasis™ UMTS/DCS/PCS Installation and Configuration Manual
1
1 Overview
MobileAccess Voasis™ wireless coverage solution provides low-cost, self-installable
UMTS/PCS/DCS in-building coverage for small and medium size enterprises (SMEs), multi-tenant
buildings, and multi dwelling units.
The solution distributes the UMTS/PCS/DCS signal from the service provider’s equipment to
antennas (VAPs) installed throughout a single floor via the existing CAT-5/6 cabling
infrastructure.
The VAPs (Voasis™ Access Pods) plug into standard (spare) Ethernet connection points on the
floor and are powered via PoE technology. All the VAPs on each floor are managed via a VCU
(Voasis™ Control Unit) located in the communication shaft. The VCU interfaces to the provider’s
equipment and provides secure, central management to the VAPs.
This plug-and play UMTS/PCS/DCS coverage solution can be easily and quickly installed by the
SME – no RF specialist required.
The following figure illustrates a typical Voasis™ installation.