User's Manual

Voasis™ Access Pod (VAP) Installation and Monitoring
30 Voasis™ UMTS/DCS/PCS Installation and Configuration Manual
5.5 Verifying System Connections and Monitoring
1. Select the Monitor tab. The following window appears. The window is divided into three
areas:
• Control Unit Configuration – shows the user defined VCU name, IP address and the HW
and SW versions. The IP address can be modified via the Configuration tab.
• Device Summary – summarizes the total number of current Alerts (RED) and previous
alerts (GREEN).
• Link Summary – shows the highest level alert on each VAP. Click the relevant button to
access detailed monitoring screen of relevant VAP.
• Active Events – system events.
Note: Any updating of the service definition: DL CF, UL CF is sent to all connected VAPs.
2. Verify the following:
• In the Device Summary area – that there are NO RED alarms. If an alarm is displayed
in the Apod area, click the relevant Link Summary button (representing the
corresponding VAP) to analyze the alarms of the corresponding VAP according to section
6.6.
• In the Link Summary area, all buttons are GREEN.
• In the Active Events area – currently not implemented.
Link Summary – click button to
access monitoring pane of
relevant POD
Active events