User's Manual

VCU Installation and Configuration
14 Voasis™ UMTS/DCS/PCS Installation and Configuration Manual
5. Power on the signal source and note that the VCU LED is lit. It indicates that RF inputs are
being received.
4.2 VCU IP Configuration
In order to enable remote management it is required to change the VCU static IP address. This
is done via a local connection from a computer (i.e. laptop) to the VCU, using a standard Web
Browser such as Explorer.
The VCU default IP address is 192.168.1.1., where it is required to pre-configure the computer
to the same Subnet as the default VCU IP addresses.
4.2.1 Configuring Your Computer to the Same Subnet as the VCU
This procedure is required in order to locally connect to the VCU.
Note: The procedure may vary, depending on your computer’s Operating System.
To configure the computer’s network parameters
1. Click the Start menu and choose Control Panel.
2. In the Control Panel, click Network and Internet Connections.
3. Click Network Connections and then double-click Local Area Connection.
The Local Area Connections Properties dialog appears with the General tab displayed by
default.
4. In the Items list, select Internet Protocol (TCP*IP) and click Properties.