User's Manual

VCU Installation and Configuration

Voasis™ UMTS/DCS/PCS Installation and Configuration Manual 13

4 VCU Installation and Configuration

This section describes the installation and configuration procedures of the Voasis™ Control Unit

(VCU). These should be performed only after planning the floor coverage and installation

locations as described in section

3.3.

The Voasis™ Single Band Solution VCU kit includes:

Table

4-1: VCU Kit

Description UNIT and P/N

Voasis™

Control Unit

(VCU) kit

Power cord

Voasis™ SW

Local

configuration

cable

(crossed RJ-

45 cable)

4.1 VCU Installation

1. Install the Voasis™ Control Unit (VCU) in the IDF/Telco closet corresponding to the floor to

be covered. The VCU can be installed in the rack or on the wall using the optional wall

mount bracket at the IDF closet along with the provider’s signal source.

2. Connect the VCU to the patch-panel that feeds the existing structured CAT-5/6 cabling

system.

3. Connect (or request the service provider’s service personnel to connect) the provider’s signal

source (pico-cell/micro-cell or BDA) to the RF ports on the VCU, through a passive interface.

4. Apply power to the VCU.

P/N: 255880010

P/N: 705B000101