User's Manual

VAP Monitoring and Configuration
Mixed Band LTE 700 MHz MobileAccessVE Instant Coverage Solution User Manual 58
If one or more alarms occur, the corresponding Status indicator will be illuminated in RED. If the
VAP is OK and no fault occurs, the Overall Status indicator will show GREEN.
Alarm Description
Service 1/2 Off User has disabled the service
DL Adjustment RED - Cable (between VCU to VAP) is too long (over 100m/300ft)
Over temperature RED - Temperature of unit exceeds normal range
VAP Faulty RED - A fault has been detected in the VAP
Overall status Indicates Fault (RED) level or GREEN if there are no faults
Note: DL adjustment alarm is raised when a VAP is connected over a cable exceeding system
cable length limitation. In such cases, the system continues to provide the wireless services, but
you should check the coverage of the VAP (as output power may be degraded due to excess
cable loss) and check the Ethernet connection (as Ethernet standard maximum cable length has
probably been exceeded).
8.3 VAP RF Parameters
The VAP Service RF sub-tabs provide the configurable RF parameters of the supported services
and correspond to the VAP element selected in the network topology tree. The displayed RF
parameters are similar for both MIMO and SISO service configuration, where each service is
configured in a dedicated tab.
To view the VAP RF Parameters
Click the Config tab from the main menu bar and then select the VAP from the network
topology and click the
Service RF sub-tab. The parameters displayed in each Service RF tab
correspond to the supported services of the selected element.
Selected VAP