User's Manual

VAP Monitoring and Configuration
Dual-Band MobileAccessVE Instant Coverage Solution User Manual 49
8.2 Viewing VAP Alarms
When a VAP element is selected in the topology tree, the Alarm tab displays the main alarms in
the unit.
To access VAP Alarms Tab
Click the Config tab in the main menu and select the VAP from the network topology tree.
Select the VAP Alarms sub tab.
If one or more alarms occur, the corresponding Status indicator will be illuminated in RED. If the
VAP is OK and no fault occurs, the Overall Status indicator will show GREEN.
Alarm
Description
Service 1/2 Off
User has disabled the service
DL Adjustment
Cable (between VCU to VAP) is too long (over 100m/300ft)
VAP Faulty
A fault has been detected in the VAP
Overall Temperature
Temperature of unit exceeds normal range
Overall Ttatus
Indicates Fault (RED) level or GREEN if there are no faults
Note: DL adjustment alarm is raised when a VAP is connected over a cable exceeding system
cable length limitation. In such cases, the system continues to provide the wireless services, but
you should check the coverage of the VAP (as output power may be degraded due to excess
cable loss) and check the Ethernet connection (as Ethernet standard maximum cable length has
probably been exceeded).