User's Manual

Inserting an RHU/AO Module in to QX Chassis I P/N 709C011101 I Page 15
Positioning New Module in Designated Slot Figure 3-3
4. Push the module all the way back until it “clicks” in to the chassis backplane.
5. Close ejectors and close both captive screws to secure the module in place. Refer to Figure
3-4.
6. For each Add-On module, connect the internal DC power feed to the module DC power
connector. Refer to Figure
3-4.
Securing Module in Slot and DC Connections Figure 3-4
NOTE: The RHU service module does not have an internal power feed connection.