User's Manual
ModuLite™ Installation Guide INSTALLATION
Foxcom Wireless Confidential and Proprietary Information
Document No. 43-93-005-05 X1 41
4.11.2. System configuration with 840
The Modulite 840 supports 1- 4 AP¶s and is used when there is a request to support increased
capacity in the same location. The following drawing describes the system configuration.
Figure 23 - system configuration with Modulite 840
The MRC antenna ports are connected to the 840 Cellular ports and are combined with the AP WLAN
signal of the AP and the Modulite 810. The Modulite 810 is an optional module. The combined signal
WLAN (from the AP’s and the Modulite 810) and the Cellular/PCS signal from the MRC are combined
together and distributed to 4 antennas.
The following table describes the configuration when a different number 1-4 AP are connected to the
840.
MRC
Modulite
AP
cisco
Modulite
optional
AP
cisco
Modulite
optional
AP
cisco
Modulite
optional
AP
cisco
Modulite
optional
ANT
ANT
ANT
ANT
Antenna
Antenna
Antenna
Antenna