User's Manual
ModuLite Installation Guide SETUP TESTS
Foxcom Wireless Confidential and Proprietary Information
Document No. 43-93-005-05 y 18
3. Setup Tests
This ModuLite™ product has been checked thoroughly before reaching the customer. Foxcom
Wireless attests to the suitability of this product for operation. Where the customer desires to
check the fitness of the product, the appropriate tests are listed on the following pages.
The following describes the equipment required for testing the system at setup.
Table 4: Required Equipment List
Required Setup Equipment Quantity
HP8753C Network Analyzer or equivalent
1
HP85046A S Parameter test set or equivalent 1
HP8594E Spectrum Analyzer or equivalent 1
Power supply /48 @ 5A 1
Signal generator HP8648B or equivalent 2
Amplifier Mini-circuit ZKL-2 or equivalent 1
Digital Multi-meter 1
RF Combiner Mini-Circuit ZAPD-21 or equivalent
with N connectors
1
High-grade 50-ohm phase matched cables:
N to N cables
N to SMA cables (in N remote type)
SMA to SMA cables (in SMA remote type)
4
2
3
Optical power meter (1310 nm) of EXFO model
number FOT-22A or equivalent
1
4 * Singlemode duplex fiber optic cable with SC/APC
connectors
3m
Calibration kit, including
Through (N-female to N-female)
Short (N-female)
50 ohm (N-female)